HOME | DD
EzziesClayWorks — Dragon #2
#dragon #polymerclay #polymerclaydragon
Published: 2015-06-18 18:03:39 +0000 UTC; Views: 89; Favourites: 3; Downloads: 0
Redirect to original
Description
My poor, burned little guy. He looks raggedy covered in white paint to cover the burns. Polymer clay again, mostly Premo and Fimo mixes.Related content
Comments: 6
You can't tell at all that he was a bit, ah, overdone! I love his facial expression and the gorgeous tail and mane!
👍: 0 ⏩: 0
He is adorable though! Make sure you have an oven thermometer. I usually cook my pieces on a tile and then cover them with parchment and sometimes aluminum foil...sometimes both. The high points (ears/wings) have scorched on me before I started doing this. My toaster oven was/is terrible about having a steady temp so as MayEsdot said, a lower temp for longer is helpful especially when you have larger pieces to bake.
Your dragons have so much personality! Love him!
Good luck, Jody
👍: 0 ⏩: 1
Thank you so much!
Yes, my next purchase for claying is an oven thermometer, haha. It's so hard without one, now that I'm scared of burning them. I love cooking them on the tiles, I started out that way with some heavier paper over top for protection from the top too.
👍: 0 ⏩: 0
He is so adorable, I really like his expression with those eyes. How are you baking him that you're having burning troubles? I bake about fifteen degrees under what the box says for around 40 minutes and check on them often and I've only ever had one Crack, and never one burn.
👍: 0 ⏩: 1
Welllll.. I may have set the temp to way higher by pure accident. Normally they're fine. I just derped pretty bad.
Thank you for the info and compliments!
👍: 0 ⏩: 1