HOME | DD
AneNJ — John God Tier Hood - back
Published: 2011-12-02 17:51:10 +0000 UTC; Views: 5828; Favourites: 98; Downloads: 283
Redirect to original
Description
Front: [link]Hood: [link]
Some time ago i was asked about the pattern i made for my John God Tier hood ... Some one else might be able to use it too? :3
2 of each piece is needed
The front and the back piece were scanned in a one-to-one scale, but they might be a bit to small when printed.
Related content
Comments: 8
hello! since i know you don't have the measurements on hand, do you think you could maybe explain what you did to make the front/back pieces of the hood? i tried to print the images out, but i don't have the correct paper size unfortunately! thank you.
👍: 0 ⏩: 1
Well an easy way would be to use a big t-shirt as a pattern - but you'd have to make sure that the hole for your head is about 40cm if you intended to use the hood-pattern i uploaded
👍: 0 ⏩: 1
thank you very much! ;u; i made three hoods as presents for some friends with your tutorial, and they all turned out perfect! thank you again for posting the patterns
👍: 0 ⏩: 1
do you still have the measurements? 
👍: 0 ⏩: 1
ohhhhh these are all great! thank you so much!
are there no measurements though on this one and the front?
👍: 0 ⏩: 1
No, the picture (if you download the full one) should be a 1:1 scale picture... though if that does not work, just fit the picture to a A4 Word document
Hope it helps - I think i lost the original pattern i made, but i'll have another look and add the measurements if i find it (since people seem to prefer measurements 
👍: 0 ⏩: 0